Netopia CLI 874 Instrukcja Użytkownika Pobierz pdf (Strona 141)

Motorola Netopia® Router CLI Commands 2-129

IKE Dead Peer Detection

Note: The commands in this section are supported beginning with Firmware Version 8.5.2.

ike phase1 { name | index } dead-peer-detection enable { yes | no }

show ike phase1 { name | index } dead-peer-detection enable

no ike phase1 { name | index } dead-peer-detection enable

These commands allow you to enable, disable, or show the status of the trafﬁc-based IKE dead peer detection

feature. Trafﬁc-based IKE dead peer detection allows IKE to negotiate RFC3706-based IKE “keepalives” with a

remote security gateway (IKE peer) that supports them. Default is no (disabled).

show ike phase1 { name | index } dead-peer-detection timeout

ike phase1 { name | index } dead-peer-detection timeout { 3-65535 }

These commands allow you to specify or show an interval, from 3 to 65535 seconds, during which IPSec trafﬁc

may be idle before the router sends a keepalive message to its peer, when ike phase1 dead-peer-detection

enable is set to yes. Default is 20 (seconds).

IKE Dead Peer Detection Conﬁguration Commands

ike phase1 { name | index } dead-peer-detection enable { yes | no }

show ike phase1 { name | index } dead-peer-detection enable

no ike phase1 { name | index } dead-peer-detection enable

show ike phase1 { name | index } dead-peer-detection timeout

ike phase1 { name | index } dead-peer-detection timeout { 3-65535 }

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 206 207

Brak uwag

Netopia CLI 874 Instrukcja Użytkownika Strona 141